M-led 2.0 projectors always on high beam - 2003 4Runner

[DKali]

Can I start with something like this and change out the h4 plugs to the correct connectors needed? https://esskcustoms.com/collections/...olarity-mod...

[DKali]

This is my preference as well. I always try and avoid cutting any of the factory harness.

I was hoping to find a pre-made solution ready...

[DKali]

Yeah crossgolf, it appears that these vehicles are ground switching rather than positive switching like most others.

Any idea where I can...

[DKali]

Yes, the Mled2 box that came with the projectors. It just has high and low beam plugs (which I connected to the vehicle high and low plugs), and then...

[DKali]

No change when switching between high and low on the stalk. They flip right to high beams as soon as the headlights are turned on....

[DKali]

Thanks! I had a look at the diagram, but not sure I understand where to put the diode? There is no relay with the projector wiring, it just connects to...

[DKali]

Installing the Morimoto M-led 2.0 projectors in my 2003 4Runner. Plugged the high and low beams up as labeled, but when I turn the lights on (low beam)...

[DKali]

Just had another look at these and tried to snap the shroud into place. It's not too far off, and I might be able to remove some material from the corner...

[DKali]

This is my first attempt at installing projectors, but it seems like the switchback is contacting the projector body near the bottom right corner when...