User Profile

[Haloruler64]

Welcome to HID Planet!

I can't give you a direct answer unfortunately, as I don't know. I do know a lot of OEM ballasts have more than two...

[Haloruler64]

It's a fine starting point, good luck!

[Haloruler64]

All igniters are either built into the ballast or connect to the ballast. They're often hanging on the AMP connectors to the bulbs. They're a critical...

[Haloruler64]

Welcome to HID Planet!

Both connect the same way, igniters go on the opposite end of the ballast to where the harness plugs in. Motocontrol...

[Haloruler64]

The knuckle-side trailing arm bushing sleeve has been such a pain. None of my saws touched it. Jigsaw, hacksaw, small hand saw... I dunno why but the...

[Haloruler64]

Cut the race off the hub, Dremel went through it very easily. Cut most of the way and tapped it off. Cleaned up the hub and proceeded to use that press...

[Haloruler64]

Got the press set, pressed out the bearing successfully at my friend's place and pressed the new one in. Felt good! End of the day win after a few hours...

[Haloruler64]

Best of luck man!

[Haloruler64]

I'm unsure actually. You ruled out the bulb, make sure you're getting 12V to the ballast, otherwise hard to say. You have a separate igniter on your ...

[Haloruler64]

Oh I misunderstood. Time to replace the ballast. Try to find a discount OEM ballast on eBay. Also check the input voltage to the ballast (not to the bulb!),...

[Haloruler64]

So the problem follows the bulb? Well then it has to be the bulb. Where did you get a new OEM bulb?

[Haloruler64]

Welcome to HID Planet!

What do you mean you had a problem swapping side to side? Sounds like a bad ballast maybe, if the bulb didn't fix...

[Haloruler64]

We can. You just posted URLs that were already embedded in between the IMG tags. Gotta post raw text. Try hitting CTRL + SHIFT + V to paste raw text....

[Haloruler64]

Basically, an LED is supposed to mimic a halogen filament. That LED does not, it just throws light everywhere. You need a quality set of LEDs. The other...

[Haloruler64]

Yeah even after you adjusted them, you have 0 distance. Those LEDs are trash and should never be used.

[Haloruler64]

You put the headlights on the car before putting the lens back on and make sure the rotation is correct. If they're going in H4 reflectors, they come...

[Haloruler64]

What do you mean by uniform?

Lightwerkz has a great video on the nut and bolt method. https://www.youtube.com/watch?v=tlCPj92IP-Q
...

[Haloruler64]

Welcome to HID Planet! Generally you'd want to do the "nut and bolt" method to recess the projector further back. You can use anything to extend...

[Haloruler64]

Check out LED demon eyes, from Profile and Diode Dynamics. That's essentially what you're thinking of. However, they're not bright enough to use as a...

[Haloruler64]

Why put an LED bulb in an HID projector? Major downgrade.