Originally posted by Riken
View Post
Announcement
Collapse
No announcement yet.
X5 LED fogs into Ford Figo
Collapse
X
-
clean install man nice work! one day ill tackle something like this.
Leave a comment:
-
Originally posted by MRauties View PostI think I need to finish this project!?!?
Leave a comment:
-
I just have a problem on the left one. Water bottle is in the way. And it needs to move about 15-20mm backwards, so lets hope I can use a tap on that space. If that doesn't work I need to cut out a section in the water bottle and make it fit.
Leave a comment:
-
And pics are coming........
This is for the second fog light
Cannot rotate them on the uploader.
Shower test done. No condensation
First one testing. Had to dremel more...................
This is just one foglight.... And OMS that width!!
Damn close to 180 deg light.
Think its damn near perfect. Just not so sure if I need to aim them a bit lower.... Looked at a few angles it doesn't blind me on any height. Unless I go down into the light.
Leave a comment:
-
Originally posted by Haloruler64 View PostLovely gift. It's not just a tool, dremels are fun as hell!
Almost done at work. Then its aiming time for them to be mounted with putty..... Think they must rename me on the forum, STEEL PUTTY! Lol.
Leave a comment:
-
Originally posted by MRauties View PostGuess who got a new dremel as a early bday gift!!
Leave a comment:
-
I wish it was a cutting disc
The famous dremel 3000 switch failure..... So now SWAMBO wants to get me the 4200 for my bday next month.
I was about 95% finished with the RHS fog. Can't even finish my projectors.... This sucks man.
Leave a comment:
-
The entire dremel, or the cutting wheel?
Hmmm. I've seen people chop a decent amount of the heat sink off - but then again, no one has ever reported back regarding LED failure or degradation as a result said cutting.
Leave a comment:
Leave a comment: