PDA

View Full Version : seek diagram connectivite ballast Valeo Dot D1s



sustanon250
January 18th, 2005, 08:49 AM
hello, I am French I am get a kit xenon " ballast Valeo Dot D1s + bulb osram Xenarc D1s " I seek the connectivite pin has 12 connector for feeds the ballast thank you
I of the photographs if need be

el'ation
January 18th, 2005, 10:25 AM
I can not understand what you are saying.


Maybe you can use this.
http://babelfish.altavista.com/

sustanon250
January 18th, 2005, 11:59 AM
sorry, I seek the diagram electric connector has 12 pins of the ballast

sustanon250
January 18th, 2005, 12:01 PM
give me your mail, I send photographs to you

NEON_2NR
January 18th, 2005, 03:41 PM
is it one of these?

http://img.photobucket.com/albums/v251/neon_2nr/stuff_034.jpg

sustanon250
January 18th, 2005, 04:33 PM
yes is this ballast

Pascal
January 18th, 2005, 08:13 PM
Just to clarify (I'm French too...), he's looking for a pinout diagram of some sort so he can wire up his D1S ballasts... they have 12 pins, which isn't obvious to figure out I guess.

EunosTT
January 19th, 2005, 12:14 AM
I have a pair, but I am not sure if am going to keep my Valeo Bi-Xenons and may need them.

sustanon250
January 19th, 2005, 05:10 AM
is the kit xenon that I to buy :
http://www.plongeur.com/forums/attachment.php?attachmentid=4787&stc=1&thumb=1

the connector has 12 pins of the ballst :
http://www.plongeur.com/forums/attachment.php?attachmentid=4788&stc=1&thumb=1
is this connector, I seek the detail for the connection electric

NEON_2NR
January 19th, 2005, 02:07 PM
well if I remember right there are only 6 pins in those. Al I did was put a couple wires with small leads on them and hooked them up to the pins inside, and then after a few tries I got the right combination and it lit up.

I will see if I can get a pic of the top of the ballast, I know who has it now... it has the pins marked.

no promises, but I wil try.

killroy77
January 19th, 2005, 02:18 PM
If you look real close at this picture the ballast only uses two wires. THis is the same plug but without all fo the extra wires. You will basically use the top left pin is the (Red) + positive and the next column over on the bottom is the (brown) - negative.

http://www.geocities.com/killroy_77audi/007.jpg

sustanon250
January 19th, 2005, 05:09 PM
:supz: I see the photograph, I connect the ballast as indicates, the bulb illuminates, is super :partyman:
I thank you infinitely